Nussbaum HL2150.034-7016, Руководство по эксплуатации

Страница: 44 / 80

44 OPI-POWER LIFT HDL 15000 - HDL 18000-V1.0-EN
6.3 Reset after an emergency discharge
i
A reset may only be done once the lift is in its
lowest position.
Access to the DIP switch may only be
done by a trained, authorised spe-
cialist.
a) There may not be any vehicles on the lift.
b) Remove the rear column covers on the operat-
ing column.
c) Loosen and remove the electrical box cover.
d) Push button 1 (reset button) and hold it down.
e) Switch off the main switch and wait 5 seconds
(hold the reset button down).
f) Switch on the main switch and wait 5 seconds.
(Hold down the reset button).
g) Release the reset button.
h) Push the “Lower” button until the lift (both plat-
forms) have reached the lowest position.
i) If required, repeat steps d) to h) to be sure that
the lift has reached the lowest position.
j) Afterwards, place the DIP switch 7 to the “on”
position.
k) DIP switch 5 remains in the “on” position.
l) Repeat steps d) to h).
m) Afterwards, place the DIP switch 7 to the “off”
position. DIP switch 5 remains in the “on” position.
n) Only 3 light diodes are permanently lit on the cir-
cuit board. An additional light diode must flash
every second.
o) The lift must be raised and lowered several times
without a vehicle while observing the entire lift-
ing and lowering process.
p) The covers must be replaced.
7 Maintenance and care
i
Before maintenance, do all preparation work so
there is no danger to life or limb or object dam-
age during maintenance and repair work.
To guarantee the largest possible availability and
functional capacity of the system, ensure the list of
any cleaning, care and maintenance work is done.
The system is to be serviced at regular intervals ac-
cording to the following plan. For intensive opera-
tion and higher degree of contamination shorten
the service interval.
The complete function of the system is to be ob-
served during daily use. Customer service must be
informed of any malfunctions or leaks.