Nu-Way G100 Universal, Руководство по установке

Страница: 3 / 16

3
E
. 0
4.
20
00
•
G
. 1
6.
11
.1
0
General information
1. General information
An oil-fired system must be installed in compliance with a number of regulations and requirements. It is
therefore the duty of the installer to be familiar with all applicable regulations and requirements. Installation,
start-up and maintenance must be performed with utmost care.
The burner must not be operated in rooms with high levels of air humidity (laundry rooms), dust or corrosive
vapours.
The universal oil burners are suitable for use with a variety of natural oils and mineral-
based oils. On account of their viscosity, these oils are not in conformity with EN 267 for
oil burners. The burners are, therefore, not licensable. An inspection to determine suita-
bility for the selected fuel type must be performed by the operator prior to acceptance of
the installation.
The design and degree of protection of the burner make it suitable for operation in
enclosed rooms.
2. Checking scope of supply and electrical ratings
Before installing the GIERSCH universal oil burner please check the items supplied for completeness.
Scope of supply:
burner, mounting unit, separate operating instructions, technical information, flange seal.
Near wear-free compressed air atomising nozzles are pre-fitted at the factory.
3. Operating instructions
This technical information should be displayed in a visible position in the boiler room as operating instruc-
tions. It is essential to write the address of the nearest customer service centre in the operating instructions.
Caution !
Improper installation, adjustment, modification, operation or maintenance may result in
physical injury or damage to property/equipment. Read the instructions prior to use.
This product must be installed in accordance with the applicable regulations
(e.g. DIN-VDE).
4. Instruction of operating personnel
Faults are often caused by operator error. The operating personnel must be properly instructed in how the
burner works. In the event of recurring faults, Customer Service should be notified.
5. Maintenance and customer service
The complete system should be checked once a year for proper functioning and leak tightness by an au-
thorised representative of the manufacturer or by another expert. We accept no liability for consequential
damage in cases of incorrect installation or repair, the fitting of non-genuine parts or where the equipment
has been used for purposes for which it was not intended.