NTT docomo FOMA D701I, Руководство пользователя

Страница: 51 / 517

48
Bef
o
re Usin
g D7
01i
Switching to English mode
Select Language
1
Press
m829
on the stand-by display.
2
Press
2
.
･
To switch to Japanese mode, press
1
.
Setting the date and time
Date and Time Setting
The time setting can be done in two ways: obtaining the time information from DoCoMo network
to adjust the time settings of your FOMA terminal, or manually input current time to your terminal.
･
If
Auto Time Set
is
ON
, automatic time correction takes place when UIM is inserted and you turn the
power on in a location where radio waves reach.
･
Automatic time correction sometimes causes a time error of several seconds. It may fail to correct the
time depending on the radio wave condition.
･
Even if time information is received while i-
α
ppli is running, time might not be able to be corrected
depending on i-
α
ppli.
･
If Auto Time Set is set to ON , time might not be set for a while.
･
When no UIM is inserted or FOMA terminal is in a location where radio waves are hard to reach or out
of the service area, the automatic time correction will be unavailable even if you turn the power off and
then on.
1
Press
m851
on the stand-by display.
INFORMATION
● If you make a call or use i-mode communication when is displayed in locations outside the service area or
where radio waves are hard to reach, move to another locations where the out of service area indication is not
displayed. However, calls may be cut off even when is displayed and you are not moving.
● When Reset Call Cost is set to
ON
, enter the PIN2 code.
● When the lighting time is set to other than
Always
in Display Light Setting if you do nothing for about 5
minutes while displaying the stand-by display or making a voice call, the display light is turned off
automatically. If
AC adapter connected
is set to
Terminal settings
or it is charged, the same situation will
occur. The display light is turned on again if there is any key operation or incoming call.
Default Japanese
INFORMATION
● The content of the setting is saved in the UIM.
●
In English mode, the character input mode changes in the following order:
半英
(alphabet)
→ 半数
(numeric)
→ 漢
(hiragana/kanji)
→ 半カナ
(katakana)
Default Auto Time Set: ON Offset: +, 00h00m