ELC-01MX User Manual
version 2.6
page 5
The EPMS-E-07 housing is designed for low-noise operation, especially for extracellular and
multi-channel amplifiers with plugged in filters. It operates with an external power supply to
minimize distortions of the signals caused by the power supply.
2.5
EPMS-03
The following items are shipped with the EPMS-03 housing:
✓
EPMS-03 cabinet with built-in power supply
✓
Mains cord
✓
Fuse 034 A / 0,2 A, slow (inserted)
✓
Front covers
Figure 2: Left: front view of EPMS-03 housing. Right: rear panel detail of EPMS-03 and
EPMS-07 housing.
In order to avoid induction of electromagnetic noise the power supply unit, the power switch
and the fuse are located at the rear of the housing (see Figure 2, right).
2.6
PWR-03D
The external power supply PWR-03D is capable of driving up to 3 EPMS-E housings. Each
housing is connected by a 6-pole cable from one of three connectors on the front panel of the
PWR-03D to the rear panel of the respective EPMS-E housing. (see Figure 3, Figure 4). A
POWER LED indicates that the PWR-03D is powered on (see Figure 3, left). Power switch,
voltage selector and fuse are located at the rear panel (see Figure 3, right).
Note: The chassis of the PWR-03D is connected to protective earth, and it provides protective
earth to the EPMS-E housing if connected.
Figure 3: Left: PWR-03D front panel view
Right: PWR-03D rear panel view.
Note: This power supply is intended to be used with npi EPMS-E systems only.