NOVUS AUTOMATION
5/57
3.
DISPLAY AND NAVIGATION
3.1
DISPLAY INFORMATION
LogBox-BLE
has an LCD display with 3 numerical lines of 4 ½ digits to display the current value of all enabled channels, as well as the minimum
and maximum values thereof. At the same time, it is possible to display the current value of up to 3 analog channels and, in a second screen, if
enabled, it is possible to display the digital input current value. In addition to channel information,
LogBox-BLE
has 7 screens with a variety of
information and features, with 24 symbols that allow for easy information visualization and diagnostics.
Below is an illustration of the display with a descriptive of functionality for each symbol present in it.
Fig. 01
–
LogBox-BLE
Display Information
●
: Stays on while the
Bluetooth
interface is available for connection or any smartphone is connected. If configured to wake up by keyboard, it
only remains on while the interface is available.
●
: When the digital channel is disabled, it remains off. When set to Counter, it remains lit. When configured as Event Log or Log Control
remains lit, flashing only when an event is detected at the digital input.
●
: Lights up when the USB cable is connected, turns off when the USB cable is disconnected.
●
: It remains lit from the moment it does the first log until the moment it stops logging. In the cases of “daily” registration, where the logging
starts and ends every day at a certain time, it will only remain lit within the configured time. Flashes at the time of a log (turns off at the time of a
log and restarts).
●
: Lights up and stays on when you enter an alarm condition, only going out when a new setting is received, or the alarm status is being
cleared. It indicates to the user that there was an alarm at some point.
●
, ,
, : Light up while the alarm conditions of the corresponding channels are satisfied: 1 (analog channel 1), 2 (analog channel 2),
3 (analog channel 3) e 4 (digital channel). When you exit the alarm condition, the flag is cleared.
●
: Indicates the battery voltage level. This symbol is updated along with the logs interval (even if the device is not logging). However, it is
done at a minimum range of 5 minutes. Thus, if the device is configured to log every 1 second, the battery indicator will only refresh every 5
minutes. If the logging interval is longer than 5 minutes, the battery indicator will update with the same logging interval.
●
: Battery over 75%
●
: Battery over 50%
●
: Battery over 25%
●
: Battery below 25% - provide battery replacement.
●
: Lights up while the “maximum” information is being displayed.
●
: Flashes to inform you that a valid data packet has been received from one of the available communication interfaces.
●
,
,
,
: Indicates which channels are enabled.
●
: Lights up while the “minimum” information is being displayed.
●
, : If the channel unit is set to °F or °C, one of the symbols is lit during channel display. Otherwise, no unit symbol is displayed.
●
: If the clock is set to display in the 12-hour format, the PM symbol lights up when the clock is displayed, and the time is later than 1 pm.
