Novitek EXCLUSIVE KIILO, Инструкция по установке и эксплуатации, Страница: 23 / 32

OY NORDIC SPA LTD | Tehdaskatu 7, 24100 Salo | www.novitek.fi
23
EN
Filtration cycle 1 is factory set to run from 8:00 pm to 10:00 pm. To change the filtration cycle’s start
time and duration, first press the MENU button
3
repeatedly until you see FLTR1 on the display. After
this, press the WARM button
1
twice and then change the start time of the filtration cycle with the
WARM and COOL buttons
1 2
. Move on to the next phase by pressing the MENU button
3
. After
setting the start time, set the duration of the filtration cycle in the same way.
Filtration cycle 2 is factory set to run from 8:00 am to 10:00 am. To change the filtration cycle’s start
time and duration, press the MENU button
3
repeatedly until you see FLTR2 on the display. You can
change the second filtration cycle’s start time and duration in the same way as the first filtration cycle.
In normal use, we recommend setting two 2-hour filtration cycles per day. In this case, the interval
between the start times of the filtration cycles must be 12 hours. For example, the filtration cycles can
be these factory set periods 8:00–10:00 pm and 8:00–10:00 am.
PLEASE NOTE! If you use the pool more frequently than three times per week, the length of the
filtration cycles must be increased.
FILTRATION CYCLES
The pool has two different settings for temperature ranges. You can set a separate temperature for
each of them. The selected temperature range is shown at the bottom of the display.
In the upper temperature setting ( RANGE ) the temperature can be set between 27 °C and 40 °C.
This setting is best suited for use when you want to keep the pool always ready for use. In the
lower temperature setting ( RANGE ) the temperature can be set between 10 °C and 27 °C. The lower
temperature range is best suited for use when the pool is not used for an extended period of time and
you do not want to maintain a high temperature.
To change the temperature setting, first press the MENU button
3
repeatedly until you see TEMP on
the display. Choose the desired mode by pressing the WARM button
1
. Save the setting and exit the
menu by pressing the MENU button
3
.
PLEASE NOTE! The selected setting is shown at the bottom of the display .
LOWER AND UPPER TEMPERATURE RANGES
The pool has an automatic preset cleaning cycle. The cleaning cycle starts when the pump has been
turned off for at least 30 minutes.
CLEANING CYCLE
STANDARD