03/10 Rev. 5.04-01
USER MANUAL
Mounting & Setting
LA-BO
7
Adjusting the dispensing edge to the vacuum grid
After fitting the applicator, the position of the vacuum grid of the applicator in
relation to the dispensing edge must be verified and adjusted if necessary.
When viewed from the side, the bottom surface of the vacuum grid must be
slightly below and in front of the dispensing edge (see [Fig. 11]).
[Fig. 11]
Position of dispensing edge to vacuum grid.
As a guideline, the vacuum grid surface should be positioned approximately
1 mm
below
the center of the dispensing edge.
To adjust: Loosen the fixing screws of the applicator’s bracket, adjust the
height of the LA-BO to the dispensing edge and retighten the screws.
