03/10 Rev. 5.04-01
USER MANUAL
Mounting & Setting
LA-BO
14
[Fig. 17]
Adjusting the air nozzles in feeding direction.
«
Loosen the 2 small black knobs (fig.17, A) and slide them towards the dis-
pensing edge for label formats with a length of less than 75 mm. In case the
label is longer than 75 mm, slide the 2 small black knobs away from the dis-
pensing edge.
«
Retighten the 2 small black knobs.
For small label formats (less than 40 mm width) it is recommended to check
if the open nozzles are centered over the width of the label.
Adjusting the air stream support
The small brass blow pipe (fig. 2) creates an air stream during the dispensing
of the label to support the label towards the vacuum grid of the LA-BO.
It is necessary to adjust the position of the blow pipe to obtain an aligned and
straight label transport to the vacuum grid.
[Fig. 18]
Adjusting the air stream support.
«
Use an Allen key of 2.5 mm to loosen the threaded pin of the blowpipe.
«
Adjust the blowpipe so the maximum number of air holes are centered to the
label width.
If there are air holes outside the width of the label, they should be closed off
by the red rings.
The air holes in the blow pipe should be directed to the vacuum grid.
A
