01/13 Rev. 5.05-01
USER MANUAL
Attachment, Setup
Rewinder
2000
16
3. Remount the guide disk.
The recesses at the inner diameter of
the guide disk (arrows) must be
positioned over the clamping bar
legs (5).
4. Push the guide disk up to the material
edge (6). Close the clamping lever.
The guide disk may not wedge in the
material.
5.
Adjust the material guides (7) on the
bouncer arm by pushing them sideways
until they correspond to the width of the
material.
The material should run evenly, and
there should be a small gap between it
and the material guides.
7
5
6
