01/13 Rev. 5.05-01
USER MANUAL
Attachment, Setup
Rewinder
2000
5
General information about setting up the printer
After mounting the rewinder you must set up the printer for operation with
the new peripheral device. This is done by selecting the appropriate
parameter in the parameter menu of the printer.
Direction of rotation
The rewinder can be operated in two rotation directions, which are
designated in a different way in the parameter menues of the printers.
Printer
Designation of the rotation direction
TTK/TTX 350
“DIRL”
“DIRR”
64-xx/AP 5.4/AP 7.t “Printing outside”
“Printing inside”
Tab. 2 The designations of the rotation direction are different in the parameter menus of
TTK/TTX 350 and 64-xx/AP 5.4/AP 7.t.
•
TTK / TTX 350:
The direction of rotation is requested after selecting the rewinder option in
the parameter menu.
•
64-xx / AP 5.4 / AP 7.t:
The rotation direction is set by a separate parameter.
Default setting: “Printing outside”.
Dancer arm deflection
In the mode "DIRR"/"Printing inside", material does not wrap itself around
the bouncer arm as much as is the case with "DIRL"/"Printing outside"
(Tab. 2). Particularly with larger roll diameters, the dancer arm would often
shoot from one extreme position to the other. The material would then be
wound up in a jolting manner.
For this reason, the software is adjusted when "Direction of rotation right"
"Printing inside" is selected – it then only uses approximately 50% of the
maximum dancer arm deflection for controlling the motor.
