01/13 Rev. 5.05-01
USER MANUAL
Attachment, Setup
Rewinder
2000
13
3. Set the rewinder pot.
(Fig. 1) so that a value
between 20 and 30 is
displayed.
Sensor test
Sens: 4.01 27
Bouncer arm in zero
position (Fig. 2); 27 =
set value.
4. Move the bouncer arm to the
final position (towards the
support leg). Check the
displayed value*.
Sensor test
Sens: 4.01 130
130 = set value
(example) in the final
position; Value
difference = 103
(o.k.)
*) The value with the bouncer arm in its final position must be at least 80 higher than the value
in zero position, which was set in step 3. Most important ist the difference between the two
values in the two end positions: the difference must equal/be higher than 80, ideally 100.
Repeat step 3 and set a higher value in the zero position, if the difference is too little.
Adjusting the sensor
The bouncer arm controls the winding speed of the rewinder by means of a
sensor. Bevor applying the rewinder for the first time, the bouncer arm has
to be brought in both end positions to adjust the sensor.
Fig. 4 Left side: bouncer arm in zero position; right side: bouncer arm in final position.
Action
Display
Note
1. Select parameter
SERVICE
FUNCTION > rewinder adjust
rewinder adjust
If 0 jobs are stored in
memory.
2. Press the Online button
rewinder adjust
Resting pos. xx
xx = actual value
supplied by the
sensor; moving the
bouncer arm alters
the value
3. Move the bouncer arm appr.
5 mm out of its resting (zero)
position. Press the Cut
button.
rewinder adjust
End pos. xx
Mind the notes
following this table!
