Novexx Solutions 64- series, Руководство пользователя

Страница: 17 / 21

01/13 Rev. 5.05-01 USER MANUAL Attachment, Setup
Rewinder 2000
17
Starting
After securing the material end, proceed as follows to start printer and
rewinder:
The printer is set to off-line mode.
Starting TTX 350 / TTK
1. Press the CUT button.
The rewinder starts rewinding, until the bouncer arm reaches the final
position. At that point, the rewinder stops.
2. Switch the printer on-line.
If a printjob has already been loaded, both printing and rewinding start
nearly simultaneously.
Cut button Start or stop the rewinder by pressing the CUT button. This works in on-line
mode as well as in off-line mode.
Material end

With no material to rewind, the rewinder stops after approx. 4 s and shows
the status report:
ST13
 Press the ON/OFF button to acknowledge the status report.
Starting 64-xx / AP 5.4 / AP 7.t
1. Press the Cut button
The rewinder starts rewinding, until the bouncer arm reaches the final
position. At that point, the rewinder stops.

It is essential to let the bouncer arm initially reach its final position after
starting. Only then, the bouncer arm takes control over the rotation speed
(explanation below).
2. Switch the printer on-line.
If a printjob has already been loaded, both printing and rewinding start
nearly simultaneously.
Cut button Start or stop the rewinder by pressing the Cut button. This works in on-line
mode as well as in off-line mode.
Material end

With no material to rewind, the rewinder stops after approx. 6 s and shows
the status report:
Status 5004
Rewinder mat. tear

Press the Online button to acknowledge the status report.
