~ 22 ~
ET-485
NOVATEK-ELECTRO
7.3 Configuring
ЕТ-485 through WEB interface
WEB-browser is used for setting via WEB-interface.
Write the unit IP-address in your browser (factory setting - 192.168.0.111) and proceed to the specified address.
Note: If the browser is set to use the proxy server, the access to the unit over local network shall be granted
only after adding the IP- address into the exceptions list as indicated in the browser documentation.
This will open home page with tabs for transferring into the other modes.
Select “Settings” to start t
he configuration of unit Ethernet network.
Password request shall appear before granting access to setup mode (factory setting 11111).
Enter password and press "Enter". If the password is correct, you shall be granted access to the setup mode. Settings
page appears with a list of parameters detailed in Table 7. If the password is incorrect, the password request shall be
displayed once again.
Click "Save" after making changes to the settings. This will check all the changed parameters. If no errors is detected,
new parameters will be stored in the memory (new parameters will become effective upon the following restart/activation of the
unit). In case of any errors detected upon clicking the "Save" button, none of the parameters is saved, while the names of
erroneous parameters are highlighted in red.
Click "Factory reset" to restore the default value of parameters.
Click "Restart" to stop all connections and interrupt all receive/transmit operations, with the following restart of the unit.
In case of any changes to the parameters, either introduced or stored in the memory, these changes shall be implemented.
