MicroE Optira Installation Manual
Celera Motion
IM-1001 | REV181211
Page 8
©2018 Celera Motion
Recommended Customer Required Parts
The following parts or their equivalents are recommended for using the optional Connector and
Calibration board.
Item
Description
Custom Connector
Parts required to connect custom cable to header connector J2 (JST SM10B-
SRSS-TB):
•
Mating Connector JST 10SR-3S
•
Crimping Tool JST YRS-859
•
Terminal Connector JST SSH-003T-P0.2 (28 – 32 AWG TIN)
Screwdriver
WiHa 26008. Small plastic screw driver to change settings on the DIP switch on
the Connector and Calibration Board.
FFC Cable
Flexible Flat Cable (FFC): 0.5 mm, Type 1, 10 P. Maximum length of 5 m.
Refer to manufacturer’s specification.
If long flex cables are needed, contact Selmark Associates for Parlex cables or
contact another equivalent manufacturer.
5.0 Design Mounting
This section contains instructions for designing the mounting scheme for installing the sensor. A
benching edge is recommended to locate the sensor to meet mechanical mounting tolerances.
Refer to the Interface Drawing for recommended location and height of edge. Use the following
reference surfaces for sensor installation.
6.0 Sensor Installation
This section contains instructions for installing the sensor and the optional connector and
calibration board.
6.1 Install Sensor
Note
: Tape or glass scales
must
be installed before installing the sensor.
Refer to the Optira
Tape and Glass Scales Installation Manual
for instructions.
Refer to the Optira Interface Drawing ID-00400 for details for sensor installation. A benching edge
is recommended to locate the sensor to meet mechanical mounting tolerances. Refer to the
Interface Drawing for recommended location and height of edge.
Note
: When installing sensor, ensure that the detector is always facing grating.
Mounting surface
Benching edge
Installed tape scale
Reference Surfaces
A
