MicroE Optira Installation Manual
Celera Motion
IM-1001 | REV181211
Page 22
©2018 Celera Motion
8.0 Order Guide
Sensor
Scales
2
- Optira Tape Scale
PIA-1000-A1-02-A
(example)
PILT-10000I-B-A
(example)
Status LED
4
A=Green, Yellow, Orange, Red
B=Red only (Alarm)
A-quad-B Output Rate
20=20 MegaStates/sec
10=10 MegaStates/sec
05=5 MegaStates/sec
02=2 MegaStates/sec
01=1 MegaStates/sec
00=Analog 1 Vpp
Index
1=LSB
1
(2.5 µm and higher)
0=Window (analog and 5 µm
only)
Alarm
A=Active High
B=Active Low
Mounting
A=Adhesive
Index Mark
B=Center of measuring length
C=Customer specified
E=None
Continuous or Individual
C=Continuous reel with cut marks
I=Individual length (default
selection for Index Mark type E)
Scale Length
3
XXXXX=Length in mm
Model
PILT=Optira Tape Scale, Standard
Resolution
5000=5 µm
2500=2.5 µm
1000=1 µm
0500=0.5 µm
0200=0.2 µm
0100=0.1 µm
0050=50 nm
0020=20 nm
0010=10 nm
0005=5 nm
0000=Analog 1 Vpp
Accessories
PI-DK
Development Kit: Connector and
Calibration Board, 200 mm FFC Cable,
3 m Controller Cable, and Z-Height Shim
Spacer for sensor installation
PI-CB
Connector and Calibration Board
PILT-AT
Tape Scale Applicator Tool
(used for lengths >0.3 m)
Sensor Type
A=Standard, 5 V Input
B=Standard, 3.3 V Input
Model
PI = Optira Incremental
Notes
:
1. The Connector and Calibration Board is required for calibration when specifying LSB for the index.
2. Scales Availability: linear glass and rotary glass scales are available: contact MicroE for more
details:
- Linear Glass Scales - Model PILG, lengths up to 130 mm
- Rotary Glass Scales - Model PIRG, diameters up to 130 mm
3. Does not apply for custom scales; contact MicroE for custom part numbers.
4. See Section 6.1.4 for details.
