Nortel 6220, Руководство пользователя, Страница: 42 / 178

43
WLAN Cable Access Point 6220 NTPM99CA 01 Rel 1.0 Issue 3 Dec 2004
Figure 3-13
Combining Back Nut with Main Nut
12. In order to prevent damage to the connector on the APU enclosure, cut
the pin of the Body connector to the length of 0.59” (15mm) with a
cutting tool.
13. Install the Body connector to the enclosure and tighten firmly.
Figure 3-14
Adjusting the length of the center conductor
14. Bring the main nut and cable to the body connector. Hand-tighten the
main nut to the body continually keeping pressure on cable towards the
body so that the center conductor will be properly seized.
15. Using two wrenches, use one wrench to hold the BODY from rotation
and the other to continue tightening the main nut to the body until a
firm stop is reached.
16. Tighten the back nut by hand, and by using two wrenches, one on the
main nut, complete the installation by tightening the back nut firmly to
secure the cable (approximately 35 lbs, ft).
17. Secure the center conductor into the equipment enclosure with the
seizing screw.
ENSURE THAT THE PIN LENGTH OF THE BODY CONNECTOR DOES NOT
EXCEED 15mm (0.59055 inch) TO PREVENT DAMAGE TO THE JOINT
PORTION OF THE HFC FILTER IN THE ENCLOSURE