Nortel 6220, Руководство пользователя, Страница: 113 / 178

114
WLAN Cable Access Point 6220 CSU NTPM99CA Rel 2.0 Issue 5 Dec 2005
Figure 4-49
Ethernet Setup window
The Secure Data Mode station will automatically set up the Ethernet
interface to use the type of medium that has been connected to the unit.
By default, the Ethernet connection is set at “Auto speed auto duplex.”
Therefore, you do not need to configure special settings for the Ethernet
hardware interface. If you wish to customize the Ethernet settings, you
can change the settings listed below. However, you do not need to
change any settings for your hardware device to be functional.
ƒ
The Secure Data Mode Station supports both Ethernet IEEE 802.3
and DIX Ethernet frame types.
ƒ
Protocols are set in the Interface Setup window of the Setup Tab.
Note: Do not change the default setup “Auto speed Auto Duplex” in this
setup window without consulting the manufacturer.
Ethernet Type
-- The Ethernet type options provide a variety of
Ethernet settings. The default value for Ethernet type will vary,
depending on your hardware device. Only the settings that are enabled
on your screen are supported by your particular hardware device. If your
switch or Ethernet card supports different speeds, you may want to
change the speed setting.
Set Up 802.11
Clicking the Setup 2 button on the Interface Setup screen displays the
802.11 Setup screen. The 802.11 Setup screen is used to set up the
interface to your 802.11 network devices.