Nortek Security & Control MIGHTY MULE MM272, Руководство по установке

Страница: 31 / 40

MM272 Installation Instructions
20
Step 3: Attach Opener Arm ( page 10 )
Step 4: Install Closed Position Stop Plates ( page 11 )
Step 5: Mount the Control Box ( page 12 )
Step 6: Connect Opener Power Cables ( page 13 )
Step 7: Connect the Transformer ( page 13 ) OR Solar Charger ( page 21 )
Step 8: Connect Battery Harness ( page 15 )
Step 9: Connect Battery ( page 16 )
Step 10: Remove Push-To-Open Jumper
A. Make sure the control box power switch is OFF.
B. Use small pliers to move the JUMPER for PUSH-TO-OPEN
applications.
C. Turn power switch ON. The control board is now configured to push
the gate open. (Keep the jumper, as it is necessary if there is ever a
need to convert the opener for Pull-To-Open).
Step 11: Set the Open Position Limit (Push-to-Open)
NOTE: Must have a transmitter that operates the gate. If not see Personalize Your Transmitter Setting on
page 18 .
The CLOSED limit is when the opener is fully retracted and the gate is in the closed position. The closed limit setting can only be
adjusted by moving the gate bracket. To achieve the optimum open position, you must adjust the OPEN Limit setting:
A. If not already ON slide the ON/OFF switch on the Control Box to the ON position and make sure the arms are in the
CLOSED POSITION (fully retracted).
B. Press and HOLD the FIRST Opener OPEN button on the control board and be prepared to RELEASE the button when
the gates reached the desired open position/limit. Use the JOG OPEN and CLOSE buttons to "fine tune" the gate position
if necessary.
C. Press and HOLD the SECOND Opener
OPEN button on the control board and
be prepared to RELEASE the button
when the gates reached the desired open
position/limit. Use the JOG OPEN and
CLOSE buttons to "fine tune" the gate
position if necessary.
D. NOTE: The opener arms must be
extended more than 7 inches to set
limits. With the gates in the desired open
positions PRESS and HOLD the SET
LIMIT button until the alarm and RED
Light come on. Then release the button.
E. NOTE: When the control box cover is removed the receiver range is reduced to less than 5 feet. Press the transmitter
button once and allow the gates to fully close. The alarm will beep once when both gates reach the CLOSED LIMIT.
This indicates the LIMITS for both arms are learned and stored in memory.
NOTE: If the gate stops and reverses you may need to adjust the Stall Force (see page 17 ).
F. Press the transmitter button and allow the gates to fully open to verify that they stop at the desired positions. Repeat
Steps B – E if correction is needed.
Step 12: Adjust Stall Force Setting ( page 17 )
Step 13: Set Auto Close Time ( page 17 )
Step 13: Personalize Transmitter Settings ( page 18 )
MIN
MAX OFF
REMOVE JUMPER FOR
PUSH TO OPEN OPTION
120
SEC.
STALL FORCE
OPEN < JOG > CLOSE
PWR.
SET
LIMIT
1st OPR.
2nd OPR.
STATUS
AUTO CLOSE
FIRST Opener
JOG Buttons
SET LIMIT Button SET LIMIT Light
SECOND Opener
JOG Buttons
MIN MAX OFF
REMOVE JUMPER FOR
PUSH TO OPEN OPTION
120
SEC.
STALL FORCE
OPEN < JOG > CLOSE
PWR.
SET
LIMIT
1st OPR.
2nd OPR.
STATUS
AUTO CLOSE
Push-To-Open Jumper