Norstar 7316, Системное руководство, Страница: 257 / 294

Glossary / 257
N0000626 03 Modular ICS 7.0 System Coordinator Guide
Coordinated Dialing Plan:
(CDP)
This dialing plan uses a steering code to
identify each node in a private network.
This one-digit code becomes part of the
set DN number rather than a separate
code. In this way, system A might have
codes in range 2100 to 2999, whereas
system B might have codes in range
3100 to 3999.
COS:
See Class of Service.
cursor:
A short horizontal line that
appears on the system telephone display
to indicate that characters can be entered
using the dialpad.
D
data terminal:
A device, such as a
modem, that can be used to transfer data
instead of sound over a telephone
network. You cannot use Norstar
programming to set up such devices.
See the documentation that
accompanies the device.
date:
See Show Time or Time and
Date.
defaults:
The settings for all Norstar
features when the system is first
installed. Settings are changed from
their defaults in programming. In this
manual, default settings are shown in
bold text.
Delayed Ring Transfer (DRT) to
prime:
After a specified number of
rings, this feature transfers an
unanswered call on an external line, to
the prime telephone associated with that
line. This feature is activated under
Feature settings
in
Sys prgrmmng
.
destination code:
A two- to seven-
digit number that the system interprets
and then translates into the digits that
you want dialed out. Both the code and
its associated dialed digits are assigned
under Routing service in Services
programming.
dialing restriction:
See Restriction
filter.
dialing modes:
≤•°¤
This feature allows you to set the dialing
mode of your telephone. Norstar
supports three dialing modes:
Automatic Dial, Pre-Dial, and Standard
Dial. All three modes support on-hook
dialing, meaning you can dial a call
without picking up the receiver. The
special features of the Automatic and
Pre-Dial modes are available only when
you dial on-hook.
Digital Mobility phones:
These
telephones connect to the system
through station modules connected to a
Nortel Networks Digital Mobility
controller.
Direct-dial:
A feature that allows you
to dial a designated telephone in your
Norstar system with a single digit, such
as the main receptionist. As many as
five direct dial sets can be established.
Each telephone in the system is assigned
to one direct-dial telephone. There is a
single, system wide digit for calling the
assigned direct-dial telephone of any
telephone. Direct-dial telephones are
established in System programming.
Telephones are assigned to a direct-dial
telephone under
Capabilities
in
Terminals&Sets
programming.
Direct-dial #:
A digit used system-
wide to call the Direct-dial telephone.
The digit is assigned under
Access
codes
in
Sys prgrmmng
.
Direct-dial number:
The digit used
to call the direct-dial telephone.
Direct inward system access
(DISA):
The feature that allows remote
users to dial directly into the Norstar
system and use Norstar features. Callers
will hear stuttered dial tone and will be
required to enter a Class of Service
password to gain access to the system.
See Remote Access.