19
2-2 OPERATING THE MACHINE
OPERATION
1. Turn on SIZER, POWERFEED, and DRILLS motors (In that order). These motors should remain
“ON” unless the machine is to be idle for an extended period of time. Please refer to figure 2.2 below.
2. Adjust the Top Section for correct door width. On the operator control panel there are two 3-position
selector switches that spring return to the center. They are under the heading “DOOR WIDTH”. One
is labeled FAST in the center and UP and DOWN. The other is labeled SLOW in the center and UP
and DOWN.
There are two methods that can be used to set door width. One is used for automatically stopping at the
standard 2 inch increments and at your pre-set door undercut. The other method is used to set the ma
-
chine for any door width between 1-6 and 4-0 by reading the door width scale, see figure 2.1.
Move the top section in the direction needed to obtain the correct setting by the FAST switch in either the
UP or DOWN position. When you are approximately 1/2 inch to 1/4 inch below the desired door width,
rotate the SLOW switch to the UP position and release it. The top section will go up slow and stop at the
next door width .
If you would like to do a special width door, rotate the FAST switch to either the UP or DOWN position,
as necessary, and watch the scale until it is near the width you desire, then momentarily turn (or bump)
the FAST switch until the scale reads the correct door width.
FIGURE 2-2
Fast Door Width
Adjustment
Slow Door Width
Adjustment
