Nordson Spectrum VT Feed Center, Руководство по эксплуатации продукта

Страница: 74 / 105

Repair
7-10
Part 1611362 − 01
E 2018 Nordson Corporation
Reassembly
1. See Figure 7-9. Using a finger, securely seat two O-rings (12) in each
middle block (8).
2. Using a large flat head screwdriver, insert two check valves (14) into
each middle block (8).
3. Using a 10-mm Allen wrench, insert two fittings (13) into each middle
block (8).
4. See Figure 7-8. To connect the two middle blocks (8), insert two fluid
tubes (9) into each middle block. Secure two O-rings (11) on each
bushing (10). Apply light pressure to secure the two middle blocks
together.
NOTE:
The orientation of the fluid tubes is critical. The longer end of
the fluid tube must be inserted into the middle blocks.
5. See Figure 7-7. Using a 4-mm Allen wrench, insert three cap screws (6)
into the tapped side of the middle block (8) to secure them together.
6. See Figure 7-6. Using a 4-mm Allen wrench, insert a total of six cap
screws (6) into each middle siphon block (8) to connect the middle
blocks to the pinch valve blocks (7).
7. See Figure 7-5. Using a 4-mm Allen wrench, insert four cap screws (4)
into the bottom siphon block (5) to connect the bottom block to the pinch
valve blocks and middle blocks.
8. See Figure 7-4. Using an 8-mm Allen wrench, insert the socket head
cap screw (1) into the bottom of the siphon block assembly (2) to secure
it to the pump manifold (3).