Nordson FoamMix Flex, Руководство пользователя по изделию

Страница: 81 / 106

FoamMix Flex Foaming System
75
Part 1129048_01
E
2020 Nordson Corporation
Operation
WARNING! Allow only personnel with appropriate training and experience to
operate or service the equipment. The use of untrained or inexperienced
personnel to operate or service the equipment can result in injury, including
death, to themselves and others, and damage to the equipment.
Controller Initial Power On
1. Power ON the ProMeter VDK controller (see Figure 15 on page 38).
2. Verify the hydraulic system is ready for operation. Check the connections
of the hoses, pressure transducers, and manifolds.
3. Verify the Mixer Motor Enable switch is in the ON position.
Bulk Melter/Unloader PID Mode
Prior to dispensing material, the Bulk melter/unloader supply system must be
placed into Automatic PID control.
1. Power on the Bulk melter/unloader.
2. Enable heat control and the pump.
3. Insert material per the instructions contained in the Bulk melter/unloader
product manual.
4. Access the Bulk melter/unloader screen (see Figure 28 on page 54) and
press the A (Automatic) button on the Bulk melter/unloader. This action
prepares the Bulk melter/unloader to dispense material when the system
is operating.
System Start
1. Press the System On button on the ProMeter VDK controller
(see Figure 15 on page 38).
NOTE: The Bulk melter/unloader might begin to run as the pressure
rises to the PID setpoint.
2. Once at pressure, the system is ready to dispense material.