Nordson FoamMix Flex, Руководство пользователя по изделию

Страница: 22 / 106

FoamMix Flex Foaming System
16
Part 1129048_01
E
2020 Nordson Corporation
ProMeter VDK Dispensing Module
The dispensing module is designed for use in form‐in‐place gasketing,
bonding, and sealing operations, with heated or unheated materials.
Mounted on the arm, wrist, or end effector of standard industrial controller,
the dispensing module meters materials close to the point of application. This
close proximity minimizes the effects of supply system pressure variations,
material viscosity changes, and drops in system pressure due to material
output. The dispensing module achieves precise bead profiles, precise shot
weights, consistent gasket sizes, and material savings.
Material can be supplied to the dispensing module by a bulk melter,
FoamMix, FoamMelt, or by any other positive‐pressure material supply
system.
Figure 4 Pro‐Meter VDK
dispensing module
Bulk Melters
Up to two Nordson bulk melters may be used in this system to feed suitable
materials. Any other use is considered to be unintended. Make sure to
observe the Nordson Safety instructions. Nordson will not be liable for
personal injury or property damage resulting from unintended use.
NOTE: The Nordson bulk melters used in the FoamMix Flex foaming system
do not have heating capability. For any questions, contact your Nordson
representative.
Unintended Use
The Nordson bulk melters may not be used under the following conditions:
S
In defective condition
S
With electrical cabinet door open
S
In a potentially explosive atmosphere
S
With unsuitable operating/processing materials
S
When the values stated under Technical Data are not complied with
Figure 5 VersaDrum bulk
unloader