Nordson Compact Manual Iso-Flo Voltage-Block, Руководство пользователя

Страница: 45 / 76

Operation
4-3
E 1996 Nordson Corporation
All rights reserved
108 390B
Issued 7/96
Manual 10-10
To perform the new system flush, use the following steps:
1. Shut off the electrostatic power supply.
2. Disconnect the fluid hose at the spray device and secure the end of
the hose in a waste container.
3. Turn on the compressed air to the system.
4. Set the system air pressure at 80 − 120 psi (5.5 − 8 bar).
5. Set the output fluid pressure to the maximum.
6. Supply cleaning solution to the Iso-Flo system and set the fluid
pressure to the maximum available (up to 150 psi or 10.3 bar).
7. With the door open, press the door interlock valve (see Figure 2-1)
and squeeze the spray device trigger (to cause air to flow) to fill the
Iso-Flo system pump with cleaning solution.
8. Release the door interlock valve. System air pressure will force the
cleaning solution out of the system pump, and subsequently out of
the hose.
9. Repeat steps 7 and 8 several times to make sure the system is
flushed thoroughly.
10. Reconnect the fluid hose to the spray device and repeat steps 7
and 8.
11. Flush the system until the cleaning solution and any remaining air are
purged from the system.
12. Fill the system with coating material.
13. Set the atomizing air pressure, fluid output, and lubricator flow rate.
14. Close the cabinet door.
Startup and shutdown procedures can vary depending on your safety
regulations and system requirements. If the solids will not settle out or
the coating material will not cure in the system, you can leave your
system full of coating material overnight.
WARNING: All conductive equipment in the spray area must
be connected to a true earth ground. Check the Iso-Flo cabinet
ground, making sure that internal as well as external
connections are clean and secure. Failure to observe could
result in property damage, personal injury, or death.
3. New System Flush
(contd.)
4. Daily Operation
Startup