Nordson Compact Manual Iso-Flo Voltage-Block, Руководство пользователя

Страница: 48 / 76

Operation
4-6
E 1996 Nordson Corporation
All rights reserved
108 390B
Issued 7/96
Manual 10-10
9. Release the door interlock valve button and trigger the spray device.
The new coating material will flush any remaining cleaning solution
out of the pump, hose, and gun.
10. Set the atomizing air pressure and fluid input pressure to the normal
operating settings.
11. Close the cabinet door, turn the power supply back on, and start
applying the new coating material.
When shutting the system down for an extended period, use the following
steps:
1. Turn off the electrostatic voltage.
2. Flush the system with compatible cleaning solution using steps 1 − 7
in System Flush and Material Change .
3. Relieve the compressed air pressure. Drain the system completely.
4. Open the cabinet door and clean the male and female couplings, the
exterior of all cabinet components, and the cabinet with a compatible
cleaning solution.
5. Check the lubricant level and refill the lubricators, as required.
6. Empty and clean excess lubricant from the filter bowls, as required.
7. Close the cabinet door.
The Compact Manual Iso-Flo system requires minimal routine
maintenance. Maintenance points are shown in Figure 2-1. To keep the
system operating at its maximum efficiency, perform the following
procedures:
For daily maintenance, use the following steps:
1. Turn off the electrostatic voltage.
2. Open the cabinet door to ground the system, then close the door.
3. Relieve the compressed air pressure.
4. Open the cabinet door and clean the couplings with a compatible
cleaning solution to prevent coating material buildup.
System Flush and Material
Change
(contd.)
5. Long-term Shutdown
6. Maintenance
Daily