Nordson Compact Manual Iso-Flo Voltage-Block, Руководство пользователя

Страница: 53 / 76

Troubleshooting
5-1
E 1995 Nordson Corporation
All rights reserved
108 390A
Issued 10/95
Manual 10-10
Section 5
Troubleshooting
WARNING: Allow only qualified personnel to perform the
following tasks. Observe and follow the safety instructions in
this document and all other related documentation.
This section contains troubleshooting procedures. These procedures
cover only the most common problems that you may encounter. If you
cannot solve the problem with the information given here, contact your
local Nordson representative for help.
Problem Page
1. Coating material does not flow when spray device is
triggered
5-2
2. Coating material flow is poor or erratic 5-2
3. Coating material is thin or watery at start-up 5-2
4. No electrostatic voltage, or the electrostatic voltage is low
or erratic
5-2
5. Lubricator filter contains coating material 5-3
6. Pump is making noise 5-3
7. Shuttle is not closing to refill pump 5-3
8. Shuttle is not disengaging when spray device is triggered 5-3
9. Shuttle couplings leaking 5-3
WARNING: Allow only qualified personnel to perform the
following tasks. Observe and follow the safety instructions in
this document and all other related documentation.
WARNING: Turn off the electrostatic voltage before opening
the Iso-Flo cabinet door. Failure to observe this warning could
result in personal injury or death.
1. Introduction