Installation
A 1-40
E
2000 Nordson Corporation
All rights reserved
41-3000
V
Issued 5/00
A3EN-04-[3V-A-AAXP]-12
Table A 1-11 Summary of Features to Customize
Control Area
Features to Customize
SYSTEM SETTINGS
From SYSTEM SETTINGS you can customize the following features, which are explained
in more detail in Table A 1-12:
Password Enable
System-Ready Time Delay period
Overtemperature Setpoint
Celsius or Fahrenheit display
Global Temperature Band setting
Individual Temperature Bands setting
Sequential or Simultaneous Startup
Display Heater Proportioning
Warning or Power notification
Ready or Pump notification
Auto-Energize Pump (piston pump units only)
Auto-Energize Pump Temperature setting (piston pump units only)
Auto-Energize Heaters
Auto-Energize Pattern Control
Time with Heaters On
TEMPERATURE
SETPOINT Temperature:
This feature sets the temperature that a zone will maintain
during normal operation.
STANDBY Temperature:
This feature sets the desired temperature to which a zone will
be reduced when the system is in the standby mode.
CLOCK
SET TIME:
This feature keeps the current day and time. The clock must be on before
you can use the HEATERS ON, HEATERS OFF, ENTER STANDBY, and EXIT STANDBY
features.
ENTER STANDBY
and
EXIT STANDBY:
This feature sets the time that you want the
system to automatically enter and exit the standby mode.
HEATERS ON
and
HEATERS OFF:
This feature sets the time that you want heaters to
automatically turn on and off.
PATTERN
CONTROL
OUTPUT 1:
This feature allows you to control how output 1 applies a pattern.
OUTPUT 2:
This feature allows you to control how output 2 applies a pattern.
LINE SPEED:
This feature allows you to enter your line speed so the pattern controller
accurately applies pattern sets to your product.
STORE:
This feature allows you to store as many as 99 pattern sets in the controller’s
memory. Once a pattern set is stored, it can be used any time.
USE:
This feature allows you to use a stored pattern set.
Programming System
Controls
(contd.)
