Super Claws Model LS-2
SAFETY
MAR/2006 (4945-3500)
Section 1-5
LOCKOUT AND/OR TAGOUT
REQUIREMENTS
The following list suggests lockout
procedures to use on all components
of the machine that require lockout due
to the storage of various forms of
energy. It is your company’s
responsibility to
Lockout/Tagout
Procedures
based on this list, train
you in their proper and safe use, and to
periodically inspect your work area to
verify that you are complying with the
procedures.
Lockout/Tagout
Procedures must be followed!
NORDCO has provided the means to
lockout this machine. NORDCO
cannot be held responsible for injury
caused by failure to comply with your
company’s
Lockout/Tagout
Procedures
.
LOCKOUT-TAGOUT PROCEDURES
The following procedures are designed to lead the operator through the steps required to shut the
machine down and prepare it for performing mechanical maintenance work. These procedures are
intended to release potentially dangerous stored energy forms and make the machine safe to begin
repairs.
SAFETY PROCEDURES
LOCKOUT/TAGOUT
1. Apply parking brakes by pushing in
parking brake button
located
on the center (front) control console.
2. Chock wheels to prevent accidental rolling of machine on grade.
3. If you have not already done so, determine which components are
to have maintenance. Place all machine mechanical systems or
workheads in the full up and locked positions.
4. When mechanical locking up of equipment is not feasible for
maintenance lower the component to the ground prior to working on
the equipment.
5. Turn
the
ignition switch
to the
OFF
position. This turns off the
power to the control circuits on the machine. Place a
TAGOUT
card
in close proximity to the ignition switch.
6. Turn
the
battery disconnect switch
(BDS)
to the
OFF
position.
Place a lockout/tagout device on the switch.
7. Bleed off hydraulic pressure.
8. Follow all of your company’s lockout/tagout rules before proceeding.
Note: When working on machine components, be aware that
moving components during repairs may create energy (ie., moving a
hydraulic cylinder). Proper precautions should be taken.
Содержание Super Claws LS-2
