29
9.
Run the free end of
C12A
through an
unused hole of the electronics enclosure.
This requires installing the Liquidtight
connector (Pt. HARDI04, HARDI05)
BEFORE proceeding to step 8.
10.
Put pins of C12A to the 6-pin and 4-pin
Weatherpack connectors (S6 and S4) which
are included in this kit according to the table
below. One connector on harness C11 may
by unused. Seal the unused connector with
a 6-pin Weatherpack plug (using C13).
The wire colors and the pin-out are
the same as ones on the mating
connectors (T6 and T4) of the
extension cable (C11).
Содержание UC4+ Roll Control
