
10
side proceeding to the largest
serial number on the right hand
side (Figure 14).
5.
Sensor cables should run through the
mounting bracket tube and then behind the
member the bracket is mounted onto.
Cable-tie the connector in place. The cable
must not be allowed to hang below the
boom (
Figure 8
).
Figure 8 – Another Acceptable Mounting
Avoid mounting sensors in
locations where they may read
from parts of the boom as shown in
Figure 9.
Figure 9 - Poor Mounting
(Sensor Reading Off Boom)
General mounting rules for UC4+
ultrasonic wing sensors:
a)
In its lowest position, the sensor mouth
must be 9 inches or more from the ground.
b)
The bottom of the sensor must be at least 9
inches in front of the spray nozzles.
c)
The bottom of the sensor must be at least 9
inches above the spray nozzles.
d)
Ensure that there are no obstructions within
a 12-inch diameter circle projected directly
below the center of the sensor.
e)
The sensor should be approximately vertical
at normal operating heights.
Figure 10 - Sensor Mounting Guidelines
A
B
B
D
C
Ultrasonic
Acoustic Cone
Содержание UC4+ Roll Control
