32
Notice:
Additional instructions are available in the
UC4+BC+HD4-INSTE (End-user manual) for
configuring spray ON/OFF signal sensing and
headland modes. With these features the
Autoslant system will function together with the
spray signal, switching boom height control on
and off with the spray signal. This function can
also be configured to raise the boom
automatically for headland turning. Refer to the
HD4 end-user manual for more information.
These additional features described are only
available when using the HARDI DAH09 PCB.
This is only applicable for systems using the
DAH09 interface and with harness 44658-78.
*
Note that on some sprayers the
slant valve wiring varies from machine
to machine. This applies to all
machines.
If the left-hand tip lifts when you press the
left button, and the right-hand button lifts
the right hand tip (as shown in
Figure 37
),
the wiring as described above is correct.
Figure 37 – Default Slant Direction
Wiring
However, if the boom does the opposite of
what is described above, it is necessary to
swap the
E
and
F
wires in the S6 connector
of 44658-78 (C12) or 44658-51 (C12A).
Содержание UC4+ Roll Control
