20
Figure 18 – Cable Configurations: C10, C01 and C04
2.
Locate the 16-pin AMP connector
attached to the sprayer’s joystick and
connect the 16-pin AMP tee connectors
of
C10
between this connection.
3.
Connect the 3-pin power connector
from
C10
to the power bar on the right
hand side of the cab.
4.
Connect the remaining 16-pin AMP
connector and one end of the UC4+
trunk cable (
C01
) to the UC4+ Control
panel.
Ensure the UC4+ control
panel’s power is off for the
remainder of the installation
(bottom of switch pressed IN).
Figure 19 - UC4+ Joystick Connection
Содержание UC4+ NITRO Miller 3200 Series
