23
9.
Install the 2-pin connectors from
C03
onto each NORAC valve as shown in
Figure 26
.
Depending on the valve block part
number,
the
“UP”
and
“DOWN”
connectors will be on opposite sides of the
block.
10.
The connectors on the valve cable (
C03
)
are marked
RIGHT UP
,
LEFT UP
,
RIGHT DOWN
and
LEFT DOWN
.
•
Cables labeled with
DOWN
go on the
same side as the hydraulic hoses on the
44933D
block.
•
Cables labeled with
UP
go on the same
side as the hydraulic hoses on the
44963D
block.
44933D
44963D
Figure 26 – Valve Cable Connections
11.
Connect the CAN Node cable (
C02B
) to
the 4-pin AMP plug on
C01.
12.
Route the CAN Node cable (
C02B
) to
the roll sensors. Follow existing cables
and/or hydraulic lines.
Содержание FLEXI-COIL 67 Series
