22
Figure 25 – Cable Configurations: C01, C01B, C04, and C10
2.
Connect the 16-pin AMP plug on the
UC4 power cable (
C10
) to the UC4
Control Panel (
E01
) in the tractor cab.
The 3-pin AMP plug tee on
C10
is
connected between the power cable from
the sprayer and the tractor power outlet
(
Figure 25
).
3.
Connect 4-pin AMP plug on the sensor
extension cable (
C01B
) to
E01
. Route
C10
and
C01B
to the tractor hitch.
4.
Connect two sets of tees on
C10
in-line
with the Flexi-Coil joystick cable at the
hitch connections.
One of the
receptacles on the tees should be marked
with a
gold
stripe. The gold connector is
to be connected to the Flexi-Coil
plug
that comes from the
sprayer
side. Plug
the other connections together.
5.
Connect the valve extension cable (
C04
)
to the 6-pin Tower on
C10
.
The valve extension cable (C04)
may be packaged with one GP end
not installed. This is normal; it
helps
installations
for
other
sprayer types. Pin this connector
on (connector included) as per
drawing in Section 5.6. TAKE
EXTRA CARE! These pins
require a special tool to remove
them if you make an error.
6.
Connect the sensor trunk cable (
C01
) to
4-pin AMP receptacle on
C01B
at the
hitch.
7.
Route
C04
and
C01
from the hitch to the
rear of the sprayer to the area where the
NORAC hydraulic valves are located.
8.
Connect the 6-pin Tower on the Valve
Cable (
C03
) to the 6-pin Shroud on
C04
at the rear of the sprayer (
Figure 27
).
Содержание FLEXI-COIL 67 Series
