19
44933D
Figure 22 – Valve Block Assembly
4.6.2 Valve Mounting
1.
Mount the NORAC valve (
V01
) on the
sprayer using the valve mounting
bracket (
B10
).
2.
As shown in
Figure 23
, screw short side
of the threaded rods into the bottom of
the valve block at least 3/8". The valve
mounting holes are drilled and tapped
3/8 NC-1" deep.
3.
Tighten the Hex nuts to hold the rods.
4.
Put the mounting bracket on the other
side of the tube and tighten with the
spring washers and the Hex nuts.
5.
Cut excess off of the rods, if necessary.
If using bolts, the bolts should
thread into the valve block at least 3/8".
The valve mounting holes are drilled and
tapped 3/8 NC-1" deep. The rule of
thumb for bolt length is 1-1/2" longer
than the tube size.
You must ensure no hydraulic
components will interfere with any
sprayer parts or be pulled tight at
any time.
Figure 23 – Valve Mounting Location
Содержание FLEXI-COIL 67 Series
