Nolan N87, Инструкции по безопасности и эксплуатации

Страница: 19 / 96

18 19
13. Assembly of inner expanded foam cheek padding
13.1 Gently insert the inner expanded foam padding into the left cheek pad fabric
lining cover (Fig. 13). Carefully spread out the padding, checking that there are
no wrinkles in the cheek pad fabric cover
13.2 Remove the upper flap “B” and lower flap “C” of the frame in respective loops
on the back of the frame itself (Fig. 12).
13.3 Unhook the three eyelets “A” of the rear frame on the left cheek pad at the three
press studs (top, front and rear) on the back (Fig. 12).
13.4 Repeat the same process with the right cheek padding.
14. Cheek Pad assembly
14.1 Insert the rear flap of the comfort padding of the left cheek pad into the cavity
between the rear seal and the inner polystyrene shell (Fig.11).
14.2 Insert the chin strap into the cavity in the cheek padding and press at the three
snap fasteners placed on the back to hook it in the relevant housing (Fig.10).
14.3 Repeat the same process with the right cheek padding.
Warning:
the buttons are hooked on only when you hear the click. Make sure
that the strap is coming out well from the cheek padding.
WARNING
- If your helmet is equipped with the double D-Ring retention system, pull it down
as indicated in the attached double D-Ring label.
- Remove the inner comfort padding only when cleaning or washing is required.
- Never use the helmet without having completely and correctly reassembled its
inner comfort padding and its cheek pads with expanded foam.
- Delicately hand-wash in lukewarm water (max. 30° C) and neutral soap.
- Rinse with cold water and dry at room temperature, away from direct sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material. It is apt to change or get
partially destroyed to help absorb shocks.
- Do not modify or alter the helmet’s internal polystyrene components in any way.
- Clean the inner polystyrene components with a damp cloth only and allow it to
dry at room temperature away from direct sunlight.
- Never use tools or equipment of any sort to carry out the steps described above.
EYEWEAR ADAPTIVE
15. Creating space for the eyewear
15.1 Remove the left cheek pad from the helmet (see instructions above).
15.2 Unhook the eyelet “A” on the rear frame of the corresponding cheek pad at the
upper press stud on the back (Fig. 16).
15.3 Remove the upper flap “B” of the frame from the loop on the back of the frame
itself (Fig. 16).
15.4 Gently remove the inner expanded foam padding from the fabric lining cover of
the cheek pad (Fig. 17).
15.5 Detach the upper part of the pre-lined inner padding (Fig. 17), then correctly
reposition the remaining part of the padding in the cheek pad.
N. B. it is recommended that you keep the removed padding for reuse in
the future.