Nolan N87, Инструкции по безопасности и эксплуатации

Страница: 17 / 96

16 17
- The special VPS fog-resistant treatment is usually sensitive to high temperatures
or heat sources. In this case, contaminations caused by contact with other mate-
rials might occur. These contaminations will cause marks and stains to develop.
In these cases (e.g. when the helmet is kept in the top case on hot days), it is
recommended to make sure the visor is not touching other materials.
5. VPS disassembly
5.1 To remove the sun screen from the helmet, open the visor completely and lower
the VPS by rotating the side slider completely upwards (Fig.7B).
5.2 Hold the left lateral part of the sun screen and pull it toward the outside of the
helmet (Fig.8).
5.3 Repeat the same operation on the right side of the helmet.
6. VPS assembly
6.1 To assemble the sun screen on the helmet, open the visor completely and push
the side slider completely upwards (Fig.7B).
6.2 Insert the sun screen left end into the left side guide until the grip pawl is hooked
in shell housing (Fig.8).
6.3 Repeat the same operation on the right side of the helmet.
WARNING
- Make sure the VPS operates correctly by moving the left side slider towards the
bottom (Fig. 7A) and the top side of the helmet (Fig. 7B) until you hear the clicks
meaning that it enters the relative positions. If necessary, repeat the above-men-
tioned steps.
- If the VPS opening/closing mechanisms are not working properly or if such
mechanisms get damaged, please contact a Nolan authorized dealer.
- Do not use the helmet if the VPS has not been assembled properly.
- Since the VPS does not assure you the same protection as the one provided by
the visor, it has to be used only when the helmet visor is lowered.
WIND PROTECTOR
(Available as standard or accessory/spare part).
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector reduces unpleasant infiltrations of air under the chin.
7. Wind Protector disassembly
To remove the wind protector, pull it towards the outside of the helmet at the three
fastening flaps (Fig. 9).
Then check that the front press studs of side cheek pads are still properly engaged.
8. Wind Protector assembly
To fit the wind protector, gently pull the front part of the left cheek padding towards
the inside of the helmet, and then insert the left side flap of the wind protector in the
corresponding housing on the lining of the inner chin guard and push it downwards
until it hooks in place completely. Then repeat this process also for the centre flap
and the right flap (Fig. 9).
Then check that the front press studs of side cheek pads are still properly engaged.