Nolan N87 PLUS, Инструкции по безопасности и эксплуатации

Страница: 16 / 116

16 17
VISOR
1 Visor disassembly
1.1 Open the visor completely (Fig.1).
1.2 Push the release lever on the left side mechanism downwards until it stops (Fig.2)
and simultaneously remove the visor from the helmet, letting out first the lower
fastening “A” and then the upper fastening “B” from their respective housing in
the side mechanism itself (Fig.3).
1.3 Follow the same steps on the right side of the helmet.
2 Visor assembly
2.1 Place the left side of the visor on the corresponding side mechanism, inserting
the upper fastening “B” of the visor in the corresponding housing in the mecha-
nism itself and aligning the lower fastening “A” of the visor over the correspond-
ing housing in the mechanism (Fig.3) .
2.2 Press the visor at the lower fastening “A” so that the release lever moves back-
wards and then place it back in position by attaching the visor to the side mech-
anism with a click (Fig.2).
2.3 Follow the same steps on the right side of the helmet.
2.4 Close the visor completely.
WARNING
- Make sure that the mechanisms are working properly. Open and close the visor
making sure that the mechanisms hold it in the different positions.
If necessary, repeat the above-mentioned steps.
- Do not use the helmet if the visor has not been assembled properly.
- Do not remove the side mechanisms from the shell.
- Should any of the side mechanisms fail or be damaged, please refer to a Nolan
authorized dealer.
•
(Available as standard or accessory/spare part).
3 Inner visor PINLOCK
®
assembly
3.1 Disassemble the visor (see instructions above).
3.2 Make sure that the inner surface of the visor is clean and check that the pin ad-
justment external levers are turned inwards (Fig.4).
3.3 Place the PINLOCK
®
inner visor on the visor.
Warning: The silicone-sealed profile of the PINLOCK
®
inner visor must be in
contact with the inner surface of the visor.
3.4 Insert one side of the PINLOCK
®
inner visor on one of the visor pins and hold it
in position (Fig.5).
3.5 Widen the visor and fasten the other side of the PINLOCK
®
inner visor to the
second pin (Fig.6).
3.6 Release the visor.
3.7 Remove the protective film from the PINLOCK
®
inner visor and check that the
entire silicone-sealed profile of the inner visor adheres to the visor.
3.8 Fit the visor on the helmet (see instructions above).
Checking and adjusting the PINLOCK
®
inner visor stretch
Check the correct PINLOCK
®
inner visor assembly by opening and closing the visor
and making sure that they do not move.