Nolan N87 PLUS, Инструкции по безопасности и эксплуатации

Страница: 15 / 116

14 15
2 TAKING OFF THE HELMET
2.1 With the helmet on and the strap securely fastened, try to take the helmet off as shown in figure
(A). In case of accident the different forces at stake and their various directions may result in
helmet rotations or they may even cause the helmet to slip off if it is not securely fastened.
2.2 The helmet should not rotate nor move on the head and should not slide off. Should the con-
trary happen, adjust strap length or change helmet size. Repeat test.
3 RETENTION SYSTEM
3.1 The retention system (strap) is factory-adjusted at a standard length. Before use, check that it
is correctly pre-adjusted.
3.2 Make sure the strap is properly fastened and tightened so as to keep the helmet firmly in place.
Anyway, before riding, make sure that the strap is well fastened under the chin, as close as
possible to the throat, but without being uncomfortable.
3.3 The correct strap tension should allow normal breathing and swallowing, but without leaving the
space of a finger between strap and throat.
WARNING
The button which may be present on the strap only prevent its end from flapping once the
strap has been fastened properly.
VISOR
- If the visor is damaged or deeply scratched causing reduced visibility, this means that the protec-
tive treatment is probably damaged so the visor is to be replaced.
- The visor can be used for the intended helmet model only.
- Do not paint nor apply stickers.
MAINTENANCE AND CLEANING
WARNING
Helmet and visor may be seriously damaged by some common substances without the
damage being however visible. Use only lukewarm water and mild soap to clean helmet and
visor, and then let them dry at room temperature away from sunrays and/or heat sources.
WARNING
Never use petrol, thinner, benzene, solvents nor other chemicals which may:
- Irreparably damage the helmet;
- Modify optical properties, reduce mechanical ones and weaken the visor protective treatment.
A
ENGLISH