Nokia Network Voyager, Справочное руководство

Страница: 472 / 700

8
Configuring Router Services
474 Voyager Reference Guide
b.
To enable Monitored Circuit, click the
M
ONITORED
C
IRCUIT
radio
button next to the interface for which you want to enable Monitored
Circuit, and then click
A
PPLY
.
To specific the virtual router ID for the virtual router to be used to
back up the local interface’s address(es), enter a value between 1 and
255 in the
O
WN
VRID
edit box. Click A
PPLY
.
Enter the IP address you want to assign to the virtual router back up in
the
B
ACKUP
A
DDRESS
edit box. Click A
PPLY
.
Note
The IP address(es) associated with the monitored circuit virtual router
must not match the real IP address of any host or router on the interface’s
network.
5.
To set a VMAC address, click the
VMAC M
ODE
drop-down window and
select either I
NTERFACE
, S
TATIC
, or E
XTENDED
. VRRP is the default. If
you select S
TATIC
, you must enter the VMAC address that you want to
use in the
S
TATIC
VMAC
edit box. Click A
PPLY
, and then click
S
AVE
to
make your changes permanent.
Note
If you set the vmac mode to interface or static, you will get syslog error
messages when you reboot, or at failover, indicating duplicate IP
addresses for the master router and backup router. This is expected
behavior since both the master router and the backup router will be using
the same virtual IP address temporarily until they resolve into master and
backup.
Removing a Virtual Router in VRRPv2
When you disable a virtual router, the VRRP operation terminates, and the
configuration information no longer displays in the browser. Fail-over of the