Nokia Network Voyager, Справочное руководство, Страница: 241 / 700

Voyager Reference Guide 241
9.
In the General Timers section, enter a value for the data interval (in
seconds) in the D
ATA
I
NTERVAL
edit box. This value represents the
interval after which the multicast (S, G) state for a silent source is deleted.
10. In the General Timers section, enter a value for the assert interval (in
seconds) in the
A
SSERT
I
NTERVAL
edit box. This value represents the
interval between the last time an assert is received and when the assert is
timed out.
11.
In the General Timers section, enter a value for the assert rate limit in the
A
SSERT
R
ATE
L
IMIT
edit box. The value represents the number of times
per second at which the designated router sends assert messages. The
upper limit is 10,000 assert messages per second.
12. In the General Timers section, enter a value (in seconds) for the interval
between sending join/prune messages in the J
OIN
/P
RUNE
I
NTERVAL
edit
box.
13.
In the General Timers section, enter a value for the random delay join/
prune interval (in seconds) in the
R
ANDOM
D
ELAY
J
OIN
/P
RUNE
I
NTERVAL
edit box. This value represents the maximum interval between
the time when the Reverse Path Forwarding neighbor changes and when a
Join/Prune message is sent.
14. In the General Timers section, enter a value for the join/prune suppression
interval (in seconds) in the J
OIN
/P
RUNE
S
UPPRESSION
I
NTERVAL
edit
box. This value represents the mean interval between receiving a Join/
Prune message with a higher Holdtime and allowing duplicate Join/Prune
messages to be sent again.
Note
The join/prune suppression interval should be set at 1.25 times the join/
prune interval.
15.
In the Assert Ranks section, enter a value for the routing protocol(s) you
are using in the appropriate edit box. Assert Rank values are used to
compare protocols and determine which router forwards multicast packets