Nogueira FTN-1000 G3, Инструкция по эксплуатации

Страница: 154 / 224

42
Instructions Manual
4. Preparation
The hydraulic flow valve (F) controls
the flow of the oil and, consequently,
the speed at which the chute rotates.
It is important to regulate this valve in
order to obtain a soft movement of
the cylinder, without making the chute
bounce during turning.
It is recommended some practical tests
to be performed, so that you can find
the best adjustment: open the valve
a bit, activate the piston and observe
the movement. If necessary, repeat
the procedure by slightly altering the
valve opening. Repeat until you obtain
a smooth movement.
If the Harvester is equipped with a semi
hydraulic chute, the deflector is controlled
mechanically and the chute turning are
performed by a hydraulic cylinder.
The deflector function is to direct the jet
of chopped crop in order to facilitate the
distribution of the forage inside the cart. It is
adjusted by the lever (L).
Move the lever (L) to direct the jet.
The trigger (B) must be attached to the
tractor, in a location easily accessible to the
operator.
The rotating movement of the outlet chute
is performed by a double acting hydraulic
cylinder. Connect the two hydraulic cylinder
hoses from the chute onto the valves from
the tractor's remote control.
Engage the hydraulic control lever located on
the tractor to activate the hydraulic cylinder
and turn the outlet chute.
4.8 - Semi-hydraulic outlet chute
How to regulate the deflector:
How to turning the outlet chute:
NOTE!
A
ROTATION:
Hydraulic
Activation
DEFLECTOR:
Mechanical
Activation
L
B
F