OPERATION
12
TrailBlazer
Series (11–01)
b.
Before the next use, return the foam media to
its place. Replace with new foam media if
necessary.
c.
Firmly snap the top piece of the dome filter
into place.
5. For the TrailBlazer and the TrailBlazer XL, each
week rinse, air dry, and return the foam
filter/diffuser at the bottom of the unit below the
motor (Figure 24).
FIG. 24
6.
For the TrailBlazer Lite, once a month (or as
necessary) take off the shroud assembly by
removing the two screws (Figure 25).
Rinse the foam attached to the inside of the
shroud with warm, soapy water and let it drip dry.
Reattach the shroud assembly before the next
use.
FIG. 25
TRAILBLAZER
XL MODEL
WARNING: To reduce the risk of fire, electric
shock or injury unplug unit from wall outlet when
not in use and before servicing.
1. Check the Micro filter EACH and EVERY time you
start and finish vacuuming. A clogged and dirty
filter restricts airflow and results in reduced suction
and overheating.
2. While vacuuming stop every two hours or as
needed to check the Micro filter. Replace with new
Micro filter when necessary.
To install a Micro filter, slide the gasket of the Micro
filter over the inlet on the inside of the top cap
(Figure 26), then replace the cap, making sure that the
latches catch correctly.
FIG. 26
NOTE: Lift both Micro filter and cloth filter out at the
same time to avoid ripping the Micro filter, especially if
it is full.
3. Once a month (or more often if necessary) hand
or machine wash the cloth filter and let it LINE
DRY. (Do not put it in the dryer).
When reinstalling the cloth filter, be sure the lip of the
filter completely covers the rim of the vacuum
(Figure 27).
