Nobis H17 V LIGHT, Инструкция по установке, использованию и техническому обслуживанию

Страница: 29 / 44

Use and Maintenance Manual model “H17 V LIGHT”
29
ENGLISH ENGLISH
Select the type of screen you want to
display with the keys
Access the relevant screen with the key
Scroll the entries to USER with the key
Access the menu by pressing key
Scroll the entries to STOVE STATUS with the key
Access the function by pressing key
OK
OK
OK
OK
To return to the SET USER screen, press
To return to the STAND-BY screen, press repeatedly.
OPERATING PROCEDURE:
MENU >> USER>> STOVE STATUS
Access the menu by pressing key
OK
ENABLING THE EXTERNAL THERMOSTAT 12.5
This paragraph explains how to enable the function
allowing to manage room temperature by means
of the external thermostat instead of using the re-
mote control. Being a continuation of the paragraph
called “CONFIGURATION OF EXT. THERMOSTAT”, this
section explains the procedure for the reading of the
device by means of the electronic board.
OPERATING PROCEDURE:
MENU >> USER >> SETTINGS >> ENABLE T.EXT
Access the user menu by pressing key
Scroll the entries to SETTINGS with the key
Access the menu by pressing key
OK
OK
Edit the pellet setting by using keys
The values vary from -5: reduction in pellet load (%)
to +5: increase in pellet load (%)
Confirm by pressing the key and move on to edit
extraction.
OK
To edit the extraction setting, use keys
The values vary from -5: reduction in extraction (%)
to +5: increase in extraction in (%)
Confirm by pressing and exit the adjustments
screen to return to the SETTINGS screen.
In the example outlined above, a percentage of -2
PELLET and +3 EXTRACTION was set;
this kind of setting results from the fact combustion
is lacking oxygen and the pellets are small in size, if
compared to the average 2cm type.
OK
During editing, remember the following:
• to return to the previous data, without saving
the last data changed, press
• if you intend to change one single datum, once the
change has been made, press multiple times
until you exit the function.
To return to the STAND-BY screen, press repeatedly
OK
The number indicated for the settings change re-
fers to a change in percentage which acts on the
default parameters set on the electronic board.
This only affects the operating phase. These values
should be changed in the event of poor combus-
tion, which, in many cases, is due to use of pellets
different from those used for testing the appliance.
12.4 STOVE STATUS
This function allows you to check if most important
parameters are working properly on the appliance.
The two screens below show the list of actual data
of the product, useful for the support service during
control operations.