Nitta NITTAOMEGA L, Инструкция по эксплуатации

Страница: 7 / 53

Safety Precautions
IV
Be sure to check the following items before starting the installation procedure:
(a) Welding power source, control power source and driving power source are all
shut off before work.
(b) All hydraulic, pneumatic, and water pressure sources are off before work.
(c) All residual hydraulic, pneumatic, and water pressure is released before
work.
(d) Note that some connectors and cables may be hot depending
on their specifications.
Turning the power supply or hydraulic/pneumatic/water pressure source ON
during the installation work without notifying the operator(s) may create an
extremely dangerous situation. Establish a procedure to always prevent such
events for safety in work areas.
Use positioning pins when you put the ATC on robots and tools.
If it is installed without using the positioning pin, the position may
move to wrong position during use, the ATC cannot be connected and
separated reliably, and a serious accident such as dropping may occur.
If the positioning pins are unavoidable, the customer should take
measures to prevent the tool from falling due to abnormal chucking or
unchucking.
Example of countermeasures when the positioning pin cannot be used
･
Perform daily inspections (checking misalignment, scratches or abnormalities
on each part such as taper pin, bush, cam, lock parts, grease application)
･
Slow down the chucking / unchucking operation as much as possible
･
Reliably capture the interlock signal.
Especially for the presence sensor of the stand, move to the next step after
confirming that the presence sensor of the tool is in the ON.
Be sure to install specified parts. In addition, when you replace parts, install
parts to their original positions and be sure to perform inspections in accordance
with certain procedures.
Ensure that the rated load (moment torque) does not exceed product's rated
value. Otherwise, not only the product functionality and life may be adversely
affected but also unexpected accident may occur.
Ensure that the electric load applied to the signal pin and electrode does not
exceed the rated voltage and allowable current. Otherwise, not only the product
functionality and life may be adversely affected but also unexpected accident
may occur.
Supply water and air to hydraulic/pneumatic, fall prevention system, and ATC
chuck/unchuck ports so as to maintain pressure within the rated range.
Otherwise, not only the product functionality and life may be adversely affected
but also unexpected accident may occur.
DANGER
DANGER
WARNING
CAUTION
WARNING
WARNING
WARNING