Nitta NITTAOMEGA L, Инструкция по эксплуатации

Страница: 6 / 53

Safety Precautions
III
c) General Precautions
Personnel engaged in installation, programming and maintenance works inside
the robot safety fence for the ATC must have expertise in robot operations
(having completed expert training). In addition, those engaged in disassembly or
assembly works of the ATC, whether in or out of the safety fences, shall read this
document, installation guide, and maintenance procedures.
For works in the safety fence area, be sure to wear appropriate clothing for the
work with personal protective equipment such as a hard hat, safety boots, etc.
For internal disassembly works for the ATC, use protective glasses for protection
against pop-out parts.
Do not use this product in any of the environments listed below.
Otherwise, operators may be injured.
- Flammable environment (containing highly volatile and flammable substances)
- Environment with explosive atmosphere (e.g. combustible gas and chemical
spattering)
- Environment exposed to water/water drops or highly humid environment
- Environment with corrosive atmosphere
- Environment with high degree of radiation
When the product is used under any of the above environment, we assume no
responsibility for any failure or damage.
Also, malfunction may occur in an environment with spattering dust, chip and
cutting oil, etc.
Do not disassemble or reassemble any parts other than those mentioned in this
manual.
A serious accident such as a fall may occur.
d) Precautions for Installation
For installation of the ATC, remove the pertinent product and place it out of the
robot safety fence as long as possible so that installation can be performed
securely.
If installation work is performed inside the safety fence, securely shut off the
power over 50V from the ATC and ensure that the robot is securely stopped
before entering into the fence area.
CAUTION
WARNING
WARNING
WARNING
WARNING
DANGER