Wireless Flash Shooting
Pairing Setting
!
Step 1: Switch all flash and Commander off
To perform wireless shooting, set the Nissin MG80 Pro commander and NAS slave
with the following procedure. When completed pairing, both of them will memorize
the data and no need to pair again after the units are switched on and off.
1. Hold the "Set" and Power “ON/OFF” buttons for 3 seconds at the same time.
3. Nissin Di700A will automatically be changed to wireless slave mode
after Pairing completed.
Nissin flash Di700A
For Sony Camera
NAS
2. “Beep” sound persists until the Pairing signal received from commander.
2. “Beep” sound persists until the Pairing signal received from commander.
Nissin flash i60A
1. Hold the Panel Lock key and the “On & Off” button of Nissin i60A
at the same time for 3 seconds.
1. Rotate the "Ch" channel dial to "Auto" auto channel mode.
3. “Beep” sound persists until the Pairing signal received from commander.
Nissin flash MG10 / MG8
2. Hold the "Open" button and the power button for 3 seconds.
1. Press the Power button 3 seconds to select Slave Mode then turn off.
3. “Beep” sound persists until the Pairing signal received from commander.
Nissin flash MG80 Pro (Slave mode)
2. Hold the Panel Lock key and the “On & Off” button of Nissin MG80
at the same time for 3 seconds.
Before usiung MG80 Pro in Commander mode, please install MG80 Pro on
camera and change the Flash mode to “WL” in camera menu.
Nissin Air R Receiver
1. Rotate the "Ch" channel dial to "Auto" auto channel mode.
2. Hold the power button for 3 seconds
3. “Beep” sound persists until the Pairing signal received from commander.
12
