SC530 INSTRUCTIONS FOR USE
ENGLISH
21
Battery charging with battery charger installed on the
machine
7.
Connect the battery charger cable (A, Figure. 17) to the
electrical mains (G) (the electrical mains voltage and
frequency must be compatible with the battery charger values
shown on the machine serial number plate (F). When the
battery charger is connected to the electrical mains, all
machine functions are automatically cut off. If the red
warning light (B) on the battery charger control panel stays
on, the battery charger is charging the batteries.
8.
When the green warning light (C) turns on, the battery
charging is completed.
9.
When the battery charging is completed, disconnect the
battery charger cable (A) from the electrical mains (G) and
wind it round its housing (D).
10.
Carefully lower the tank.
NOTE
For further information about the operation
of the battery charger (E, Figure. 17), see the
relevant Manual.
BRUSH/PAD CLEANING
CAUTION!
It is advisable to use protective gloves when cleaning the brush/pad because there may be sharp
debris.
1.
Remove the brush/pad from the machine, as shown in the Use chapter.
2.
Clean and wash the brush/pad with water and detergent.
3.
Check that the brushes/pads are in working condition and not excessively worn; if necessary replace them.
SOLUTION FILTER CLEANING
1.
Drive the machine on a level floor.
2.
Ensure that the machine is off and the ignition key (54) has
been removed.
3.
Close the solution tap (A, Figure. 18) under the machine,
behind the right rear wheel. The tap (A) is closed when it is
on the position (B) and it is open when it is on the position
(C).
4.
Remove the transparent cover (D), then remove the filter
strainer (E). Clean and install them on the support (F).
NOTE
The filter strainer (E) must be correctly
positioned on the housing (H) of the support
(F).
5.
Open the tap (A).
Figure 17
F
G
VACUUM TRACTION BRUSH
C
B
E
D
A
Figure 18
H
E
D
E
G
F
B
C
A