SC530 INSTRUCTIONS FOR USE
ENGLISH
13
BRUSH/PAD-HOLDER INSTALLATION AND UNINSTALLATION
NOTE
Install either the brush (A, Figure 5) or pad-holder (B and C, Figure5) according to the type of
floor to be cleaned.
CAUTION!
Before installation or uninstallation of brush or pad-holder, make sure all the switches on machine
are in off position and lifting up the squeegee from the floor. The operator must be equipped with
suitable personnel protection devices such as gloves to reduce the risk of accidents.
Proceed as following:
1.
Insert the ignition key (54) and turn it to "O".
2.
Lift the deck by pressing the pedal (10).
3.
If equipped, turn the speed adjuster (56) to idle by turning
it counter-clockwise.
4.
Place the brushes (A, Figure. 5) or the pad-holder (B)
under the deck (21).
5.
Lower the deck on the brushes/pad-holders by pressing the
pedal (10).
6.
Turn the ignition key (54) to "I".
7.
Press the Brush/pad-holder and vacuum system switch (60).
8.
Press one of the safe switch (50) to engage the brush/pad-
holder, then release it. If necessary, repeat the procedure
until the brushes/pad-holders are engaged.
WARNING!
(Only for machine with traction): Turn the speed adjuster (56) counter-clockwise to drive the
machine at the minimum speed.
Slightly press the safe switch (50), otherwise the machine starts to move.
To engage the safe switch (50) which turns on the brush/pad-holder motor.
9.
To remove the brush/pad-holder lift the deck by pressing the pedal (10), then press the switch (58),the brush/pad-
holder will be remove.
ADJUSTING THE BALANCE OF SQUEEGEE
1.
Install the squeegee and screw up the nut (H), then
connect the vacuum hose (G) to the squeegee.
2.
Adjust the squeegee by squeegee adjusting handle (A,
Figure 6).
a)
If there is gap between the ground and middle section of
rear squeegee blade (B), adjust the knob (A) in
counterclockwise direction (F) until all section of rear
squeegee blade good contact with ground, the front
blade touch the ground slightly.
b)
If there is gap between the ground and both end section
of rear blade(C and D), adjust the knob (A) in clockwise
direction (E) until all section of rear blade good contact
with the ground, the front blade touch the ground
slightly.
Figure 5
A
C
B
Figure 6
E
F
A
D
B
C
H
H
G
