Nilfisk-Advance rs 502, Руководство пользователя

Страница: 132 / 210

ENGLISH USER MANUAL
20 33019741(1)2009-03 A RS 502
Stopping the machine in working mode
To stop the machine release the pedal (4, Fig. E). 1.
To stop the machine quickly, press also the brake pedal (5).
Engage the parking brake with the lever (7, Fig. E).
2.
Turn off the dust control system water pump with the switch (19, Fig. D). 3.
If open, close the dust control system valves (8 and 9, Fig. E). 4.
Lift the safety fl ange (24, Fig. E), then lift the suction inlet and side brooms with the lever (12). 5.
Turn off the suction fan with the lever (14, Fig. E). 6.
Turn the engine throttle lever (16, Fig. E) to idle, and hold it in this position for a few minutes to let the system stabilize. 7.
Check that the hopper (12, Fig. G) is lowered and that the warning light (26, Fig. D) is off. 8.
Turn off the engine, by turning the ignition key (17, Fig. D) counterclockwise, to the end of stroke, then remove it. 9.
Engage the parking brake with the lever (7, Fig. E). 10.
MACHINE OPERATION
Avoid stopping for a long time with the machine in the same position and the brooms rotating: this could create unwanted marks on
the
fl oor.
Bulky debris collection
To collect bulky debris, lift the front skirt (24, Fig. G) with the switch (13, Fig. E). 1.
Note that, while the skirt is lifted, the machine suction power decreases.
To lower the front skirt (24, Fig. G), press the switch (13, Fig. E) again.
If necessary, to collect bulky debris, it is also possible to remove the front skirt (24, Fig. G); remove it according to the following
2.
procedure:
Lift the brooms, then stop the machine and turn off the engine. •
Remove the clip (1, Fig. M) and disconnect the tie rod (2) from the skirt (3). •
Remove the skirt (3) by withdrawing it from the hinges (4). •
Turn on the machine and start working again. •
Install the skirt (3) in the reverse order of removal, after stopping the machine and turning off the engine. •
If necessary, adjust the broom speed with the knob (28, Fig. E) (optional).
3.
NOTE
When the hopper is full, the machine cannot collect dust and debris anymore.
After each working cycle, and when the hopper (12, Fig. G) is full, it must be emptied. For the relevant procedure, see the next 4.
paragraph.